公司名称：山东创伟外墙保温材料有限公司

填缝剂的黏合性非常的强，收缩比较小，颜色的固着力强。为了让填缝剂的作用发挥到*大效果，所以我们就需要注意A级防火保温板施工的一些事项。
A级防火保温材料
Very strong adhesive sealant, shrinkage is relatively small, the color of the solid strength. In order to make the sealant function to the maximum effect, so we need to pay attention to some matters a fireproof insulation board construction.
1、填缝剂在A级防火保温板施工七天后方可施工，施工温度不可低于0度。
1, sealant in a fireproof insulation board construction seven days before construction, construction temperature not lower than 0 degrees.
2、在*初的72小时内，必须注意防止填缝剂干燥（特指室外暴露于阳光下的施工面），此时可用天然牛皮纸覆盖施工面（*好不要用塑料布或报纸替代），以防止其它施工作业把新做好的连接缝弄脏。
2, in the first 72 hours, must pay attention to prevent the sealing agent drying (especially the outdoor construction surface exposed to the sun), available at the time of natural kraft paper covering the construction surface (preferably not replaced with plastic cloth or newspaper), to prevent other construction work to do the dirty seam connection.
3、必须将裂缝表面或A级防火保温板表面及连接缝清理干净，用湿布将其表面弄湿，但不要留积水，以减少裂缝上的小孔吸入颜料和水泥，并且保证其着色和*终凝结度。
3, must be the surface cracks or a fireproof insulation board surface and the seam is clean, use a damp cloth to the surface wet, but do not leave the water, to reduce the hole crack inhalation paint and cement, and ensure the coloring and final condensation degree.
4、为了有助于控制颜色和减少粉化，在1-2小时内使用棉布或清洁的干毛巾擦拭表面即可。
4, in order to help control color and reduce the powder, in 1-2 hours, use cotton cloth or clean dry towel to wipe the surface